9-Pin Connector; Brown; Black; Red/White - Ultra Start 1172 Installation Manual

PAGE 7
WIRE DESCRIPTION
SYSTEM PROGRAMMING - Menu 1

9-PIN CONNECTOR

YELLOW
PIN 1

BROWN

PIN 2

BLACK

PIN 3
RED /WHITE
PIN 4

WHITE/BLUE

PIN 5

PINK

PIN 6
GRN/WHITE
PIN 7

BLUE/WHITE

PIN 8
BLUE
PIN 9
Supplies one .75 second pulse when locked and one .75 second pulse
RE-ARM (-)
after remote start shutdown. Factory alarm re-arm/ RAP shutdown.
PROGRAMMABLE
Supplies one .75 second pulse when the unlock button is pressed and
DISARM (-) one .75 second pulse before remote start activation. For factory alarm dis-
arm/ or as computer "wake up".
Default- AUX channel output when the # button is held(no car finder on #)
AUX #1
Programmable for a (-) Ignition or (-) Dome Light output with the (#)
OUTPUT (-)
button activating car finder mode.
PROGRAMMABLE
Output activates when the unlock button is held for at least 3 seconds.
TRUNK
The output will stay on for up to 5 seconds if the button is held.
RELEASE (-)
Programmable for Dome light Output or 2nd Unlock Output.
Connect this wire to the factory horn wire of the vehicle. This connection
HORN
will provide audible confirmation when programming and when a function
OUTPUT (-)
is performed.
PROGRAMMABLE
BRAKE
This wire must be connected to the wire at the brake switch that changes
SWITCH
to 12volts when the brake is pressed.
INPUT (+)
Connect this wire to the supplied hood pin switch. If ground is detected on
HOOD PIN
this input the remote starter will not activate. Programmable for N/C hood
INPUT (-)
pin type (Factory hood pin)
This wire is used to to detect when the vehicle has started. The Tach
TACH WIRE source is typically taken from a fuel injector, coil, coil pack or crank
INPUT (A/C) position sensor. The Tach wire is generally found as the opposite from the
common wire at the coil or fuel injector.
GLOW PLUG
Default Gas Mode/ Positive Glow Plug. Programmable.
INPUT (+)
72 SERIES
INSTALL MANUAL