Wire Description; 3-Pin Bypass Module Connector; Red; White - Ultra Start 1172 Installation Manual

72 SERIES
INSTALL MANUAL
6-PIN CONNECTOR

YELLOW

PIN 1
GREEN
PIN 2

RED

12v INPUT 30A
PIN 3
RED 12v INPUT 30A
PIN 4
SELECTABLE

WHITE

PIN 5

BLUE

PIN 6
2-PIN CONNECTOR

BLACK

PIN 1
PARK LIGHT
WHITE
PIN 2
(SELECTABLE)
3 PIN DOOR LOCK CONNECTOR
GREEN
PIN 1
12V + DOOR
N / A
PIN 2
LOCK INVERTER
(-) UNLOCK
BLUE
PIN 3
3 PIN BYPASS MODULE CONNECTOR
WHITE/ GROUND WHEN
PIN 1
VIOLET
BLACK
PIN 2
RED 12 VOLT OUT
PIN 3
STARTER This wire will test 0V with the key off, in the Accessory position and when the
OUTPUT Ignition is in the on. This wire is 12volts in the start/ crank position only.
HEATER This wire will test 0V when key is off, 12volts in the ACC and IGN positions
OUTPUT and off during the start/ crank position
Connect to constant 12volts. This input supplies the 12volt power for the
IGN 1, IGN 2 and Park Light output.
Connect to constant 12volts. This input supplies the 12volt power for the
Accessory and Starter output.
2nd Ignition, Accessory or Start output. Programmable.
OUTPUT Note: This output does not switch to default when the system is reset.
IGNITION This wire will test 0V in the off and Accessory positions then switch to12volts
OUTPUT
in the Ignition and Start and run position.
SYSTEM
Connect to chassis ground.
GROUND
Connect to the vehicles positive park light wire or change the jumper and
OUTPUT connect to the vehicle negative park light wire. The default position of the
jumper is Positive Park Light Output.
(-) LOCK Connect to lock wire from the switch on vehicles with a negative type switch.
OUTPUT **LOW CURRENT ONLY**
This output will supply 12volts for a plug-in type door lock module. Do not
use this input to power-up relays **LOW CURRENT ONLY**
Connect to unlock wire from the switch on vehicles with a negative type
OUTPUT switch. **LOW CURRENT ONLY**
This wire is used for bypass module activation or adding additional relays to
RUNNING be triggered only when the remote starter activates.
GROUND This wire can be used to supply ground to your bypass module.
This wire can be used to supply 12 volts to your bypass module. May not be
available on all harnesses. **LOW CURRENT ONLY**
SYSTEM PROGRAMMING - Menu 1

WIRE DESCRIPTION

PAGE 6