Table of Contents
Advertisement
Page 20
J E q - - i j
Refer to Pictorial 8 for the following steps.
( )
Locate the cabinet, the reinforcing plate,
the handle, and the two #10 x 1/2" sheet
metal screws.
( )
Using the #10
x
1/2" sheet metal screws,
fasten the reinforcing plate and handle to
the top of the ca5inet a s indicated in Pic-
torial 8.
( )
Insert the plug of the line cord through the
hole in the r e a r of the cabinet, then fit
the cabinet over the chassis and inside of
the front panel flanges. Make sure that none
of the transformer leads or hookup wires
a r e pinched between the cabinet and front
panel.
( )
Secure the top of the cabinet with two #10
x
7/8"
sheet metal screws, placed through
the cabinet and into the speednuts on the
end flanges of the vertical support brackets.
( )
Mount the four rubber feet to the bottom of
the cabinet with #10 x 7/8" sheet metal
screws. Each screw should be placed through
a rubber foot, then through the cabinet and
into a speednut on the flanges of the trans-
former chassis.
If
difficulty
is
experienced in installing the
cabinet, o r
if
the cabinet does not fit properly
after tightening i t s mounting screws, remove
the cabinet and adjust the positionof the vertical
support brackets. This can be accomplished by
slightly loosening the vertical support bracket
mounting screws, repositioning the brackets, and
retightening the screws.
This completes assembly of the Isolation
Transformer. Read the APPLICATION
and
OP-
ERATION sections of the manual to gain a
thorough understanding of how to use this
instrument effectively.
Advertisement
Table of Contents
