Table of Contents
Advertisement
Page 14
&%+
- : - 9
Pictorial 5
Refer to Pictorial 5 for the following steps.
NOTE: Each of the wires mentioned in the
next five steps a r e already connected at oneend
to a component on the front panel. In each step,
carefully trace the wire back to i t s front panel
origin before connecting
it
to terminal s t r i p L.
Pictorial
2
(fold-out on Page 10) shows front
panel component designations.
( ) Connect the wire coming from lug 1 of fuse
holder J to lug 2 of terminal s t r i p L (NS).
( ) Connect the wire coming from lug
2 of toggle
switch K to lug 4 of terminal s t r i p L (NS).
( ) Connect the wire coming from lug 5 of slide
switch E to lug 4 of terminal strip L (NS).
( ) Connect the wire coming from lug 3of slide
switch E to lug 1 of terminal s t r i p L (NS).
(
)
Connect the wire coming from binding post
C
to
lug 3 of terminal strip L (NS).
( ) Connect either black transformer lead to
lug 1 of terminal s t r i p L (NS).
(
)
Connect the other black transformer lead
to lug 4 of terminal s t r i p L (S-3).
( ) Referring to Detail 5A, install the line cord
and line cord strain relief in the hole in the
r e a r of the transformer chassis. About 1"
of the outer line cord insulation should
extend beyond the s t r a i n relief, inside of
the chassis.
Advertisement
Table of Contents
