Direct Operation; Remote Operation - Travis Industries GreenSmart 2 Setup Instructions

Direct Operation

The fireplace may be directly operated from the battery holder. The three positions are below (see below):
ON – Burner turns on (regardless of transmitter settings).
OFF – Burner turns off (regardless of transmitter settings).
REMOTE – Burner is controlled by the transmitter.
NOTE: When the battery holder switch is turned to ON or OFF, the mode settings (Flame Height, Comfort
Control) will remain in the same state as before the switch was moved (i.e.: the IFC "remembers" the last
setting). If you wish to adjust the mode settings use the transmitter mode button to adjust the settings
(see "Mode Controls" on page 6). The thermostat and burner on/off operating functions will not work on
the transmitter.

Remote Operation

When the switch on the battery holder is set to "REMOTE" the transmitter operates the fireplace. Once
you understand how the transmitter works, you will be able to operate your fireplace quickly and easily.
Display Overview
The transmitter display has four main sections (see below).
Listen for the "Beep"
Each time you press a button on the transmitter that controls the fireplace, a "beep" will come from the
IFC. When you change thermostat target settings the IFC will not beep.
NOTE: When the batteries start to get low, the IFC will beep intermittently. When the batteries are nearly
depleted, the IFC will no longer beep. See "IFC Batteries" on page 8).
Page 4 of 10
GreenSmart
(SKU 99300688, 99300690, 99300692, 99300693)
Thermostat Display
Room Temperature Display
F
ON
Read-Out (Thermostat Setting, Function, etc.)
Mode Display (Flame, Blower, Light, Comfort Control)
17601740.docx — 11/3/16
TM
2 Remote Setup Instructions
© Travis Industries, Inc.