Russell Hobbs RHMF80 Instructions And Warranty page 6

OPERATING INSTRUCTIONS
Operating through Control Panel
1. Ensure the unit is on a firm, flat surface. Plug the unit into the wall socket and
switch on the wall socket. Use the remote control or the on-board control panel
to select the following:
2. Press "ON/SPEED" button, to choose the wind speed-Low, Med, High that
matches the light on the control panel.
3. Press" SWING" button, to change the wind direction, the corresponding light
will switch on.
4. Press this button again to stop the oscillation.
5. The wind angle of upwards and downwards is done manually. Set the desired
wind angle moving the guard and the motor of the fan up and down.
6. Press" MIST" button, if the light is on, the mist will spread out of the front mist
plate.
7. "MIST "button can be operated separately. Or worked together with the fan, this
will ensure cool wind. If the mist function is used separately, it can increase
humidity in the air.
Note: When the mist function is on, an apparent mist will be observed. Such
emission is normal and you do not have to change the settings of your appliance.
Do not take out the plastic tube in the front side of your fan. Otherwise, the metal
components of your fan will easily rust.
Operating through Remote Control
OFF
Switches off the fan and stands it by.
ON/SPEED
Switches on the stand-by fan and helps you choose the wind speed
Low, Med, High.
TIMER
Sets the time between 2 and 4 hours and switches the fan off after pre-
set time.
Press "TIMER" button to set the time using the timer function. There are
2 indicator lights of automatic timing. To set a time of 2 hours you need
to press the button once and to set 4 hours of running time you need to
press it 6 times and all the indicator lights will then go on.
SWING
Press "SWING" button, to change the wind direction, meanwhile the corresponding light
will switch on. Press this button again to stop oscillation.
6