Russell Hobbs RHMF80 Instructions And Warranty page 5

FILLING THE HUMIDIFIER TANK
1. Open the water tank cover using the small flap on the right hand side of the unit.
2. Using the handle on the water tank, lift the water tank in an upward direction, and
pull it out.
3. Tip the water tank upside down and remove the screw cap. Add water to the tank, up
to 1.5 litres. Do not place any liquids in the water tank other than water. Only add
water that is room temperature. Do not use hot water in this unit.
4. Replace the screw cap, and make sure it is fully tightened.
5. Turn the water tank upright and place back into the body of the unit. Ensure that the
water tank sits firmly in the body. Close the water tank cover.
6. Your Russell Hobbs Mist Fan is now ready for use.
Note: Do not take out the water tank before unplugging the power cord. Hot
water (40℃ and above) is not allowed to be added in the water tank.
Note: Do not add dirty or chalky water in your tank, add fresh water to ensure a
longer life for your fan.
5