Table of Contents
Advertisement
If An Alarm Sounds
If an intrusion alarm sounds (continuous siren tone), the alarm may not be silenced by entering your Access
Code. If the alarm was unintentional, call local authorities immediately to avoid an unnecessary response.
You can determine the source of the alarm by following the instructions in the Alarm Viewing section of
this manual. Once the source of the alarm has been corrected, the system can be restored to its original
armed state.
Zone Bypassing
Use Zone Bypassing when access is needed to part of the protected area while the system is armed.
Bypassed zones will not cause an alarm. Zones that are temporarily out of service due to damaged
wiring or contacts may be bypassed to allow system arming (partial protection) until repairs can be made.
Zones cannot be bypassed after the system is armed.
To bypass zones:
Enter [ ][1][Zone number(s) to be bypassed]
Enter zone number(s) as single digits (1-4).
As each zone is bypassed, the Zone Light will come ON. If a zone is bypassed in error, press that zone
number again and the Zone Light will go OFF indicating that the zone is not bypassed.
Press [#] to return to "Ready".
To recall last group of zones bypassed:
Enter [ ][1][9]
Zone lights for the last group of zones bypassed will come ON to show which zones are bypassed. If you
wish to add or delete a zone from the group, press [#] to exit then follow the instructions for zone
bypassing as described above.
Press [#] to return to "Ready".
For security reasons, your installer may prevent the bypass command from working on certain zones.
The "System" light is ON as long as ONE or more zones are bypassed. Do not unintentionally arm the
system with zones bypassed. Zone bypasses are automatically cancelled each time the system is
disarmed and must be re-applied before the next arming.
Viewing Trouble Conditions
The PC1150 continuously monitors a number of possible trouble conditions. If one of these trouble
conditions occur, the keypad will beep twice every 10 seconds and the keypad "System" indicator will
light. Pressing any key on the keypad will silence the sounder but the "System" light will remain ON until
the trouble condition is cleared. If you cannot determine the cause of the trouble condition, contact your
installer for assistance.
Press [ ][2] to display the type of trouble. A Zone Light will come on to indicate which type of trouble
exists. Press [#] to return to "Ready".
Light
Trouble Condition
1 ................. Low or disconnected stand-by battery
2 ................. Loss of AC power (Loss of AC power will turn on the
.................. trouble light but keypad sounder will not sound)
3 ................. Siren fuse open
4 ................. Unsuccessful communication attempt
"Ready" ........... Not used
"Armed" ........... Loss of time on the system clock
6
Advertisement
Table of Contents
