Table of Contents
Advertisement
VZ-CMK04
Installing the Mounting Brackets (cont'd)
Griplate™ Installation
ViewZ's Universal Washers are designed to
accommodate the various M4, M5, M6 and M8 hole
sizes required by flat panels.
Do not place excessive pressure on the back of
the flat panel, as this may damage the flat panel.
The Universal Washer must be installed between
the head of the mounting screw and the mounting
bracket as shown with dimples facing down.
Does the flat panel have:
●
Recessed mount points?
●
Uneven mount points?
●
A curved back?
●
Any obstruction near the mount point?
If Yes, you must install Universal Spacers. Remove the
mounting brackets, Universal Washers, and mounting
screws from the back of the flat panel. Proceed to the
"Universal Spacer Installation" below.
If No, skip to the "Attaching the Mounting Bracket to
the Flat Panel" on page 10.
Universal Spacer Installation
ViewZ's Universal Spacers allow you to attach the
mounting bracket to flat panels which have recessed or
uneven mount points. Each Universal Spacer adds ¼˝
to the distance between the mounting bracket and the
flat panel.
The Universal Spacers must be stacked and
oriented as shown.
The Universal Spacers must only be installed
between the mounting bracket and the flat panel.
The Universal Spacers will fit M4, M5, M6 and M8
screw sizes.
Proceed to the "Attaching the Mounting Bracket to
the Flat Panel" section.
Installation Instructions
Visit the ViewZ website at http://www.viewzusa.com
M8
M5, M6
M4
Mounting Screw
Universal Washer
Mounting Bracket
Flat Panel
Universal Spacer
Mount Point
1˝
¼˝
Page 9
Advertisement
Table of Contents
