Table of Contents
Advertisement
VZ-CMK03
Installing the Mounting Brackets (cont'd)
Griplate™ Washer Installation
ViewZ's Griplate™ washers are designed to
accommodate M4, M5, M6 and M8 hole sizes required by
flat panels.
Do not place excessive pressure on the back of the
flat panel, as this may damage the flat panel.
The Griplate™ washers must be installed between
the head of the mounting screw and the mounting
bracket as shown.
The dimples on the Griplate™ washers must be
oriented as follows:
●
The Griplate™ washers installed at the top
of the flat panel must have the points of the
dimples facing away from the flat panel.
●
The Griplate™ washers installed at the bottom
of the flat panel must have the points of the
dimples facing towards the flat panel.
Does the flat panel have:
●
Recessed mounting points?
●
Uneven mounting points?
●
A curved back?
●
Any obstruction near the mounting point?
If Yes, you must install nylon spacers. Proceed to
"Nylon Spacer Installation" below.
If No, you do not need nylon spacers. Proceed to
"Attaching the Mounting Brackets to the Flat Panel"
on page 10.
Nylon Spacer Installation
ViewZ's nylon spacers allow you to attach the mounting
bracket to flat panels which have recessed or uneven
mounting points. Each nylon spacer will add distance
between the mounting bracket and the flat panel.
The nylon spacers must only be installed between
the mounting bracket and the flat panel.
The nylon spacers will fit M4, M5, M6 and M8 screw
sizes.
Installation Instructions
Visit the ViewZ website at http://www.viewzusa.com
Top
Griplate™ Washer
Griplate™
Dimple Orientation
Washer
Bracket
Flat Panel
Mounting Point
M8
M6
M5
M4
Mounting Screw
Mounting Bracket
™
Griplate
Washer
Flat Panel
Nylon Spacer
Mounting Point
Bottom
Griplate™ Washer
Dimple Orientation
Page 9
Advertisement
Table of Contents
