Subscribe to Our Youtube Channel
Related Manuals for ViewZ VZ-AM03
Summary of Contents for ViewZ VZ-AM03
- Page 1 VZ-AM03 Wall Mount with level, rotation and tilt adjust VZ-AM03 INSTALLATION INSTRUCTIONS sales@viewzusa.com www.ViewZUSA.com 1-714-996-1177...
- Page 2 Use with products larger than the maximum weight and size may causing serious injury and product damges. Before using or installing mount, please remove monitors or object from the mount. If the mount is not suitable for a monitor - max. weight capacity & recommended monitor size, please contact ViewZ. If customer install mount and get damages without knowledge, ViewZ will not be responsible.
- Page 3 Tape Measure Assembly Components Your ViewZ mount product is shipped with all proper installation hardware and components. If there are parts missing and/or damaged, please stop the installation and contact ViewZ USA at (888)-998-4399. - Arm and Wall Plate (1 pc.) - Front Support (1 pc.)
- Page 4 Too short Too long When attaching brackets to the flat screen, you should be careful to screw and be sure those screws do not bottom out in the mounting holes. Correct Correct Visit the ViewZ USA website at http://www.viewzusa.com Installation Instructions...
- Page 5 Make sure the depth is not less than 2 3/4" (70 mm) 4) Mount wall plate using 4 sets of 5/16 lag bolts (E) and washers (F) with a 1/2" socket wrench (not included). Installation Instructions Visit the ViewZ USA website at http://www.viewzusa.com...
- Page 6 (B) and keep them to re-build. 2) Insert the extension into the B. 3) Fasten the nuts and screws. 4) Hang onto A, then asseble them by using pre-installed screws & washers B & C Visit the ViewZ USA website at http://www.viewzusa.com Installation Instructions...
- Page 7 1) Hang monitor with brackets onto the arm extensions and C. Secure Monitor 1) Secure the monitor by using pre-installed screws on brackets against the arm extensions and C. Lock Screw driver Pre-assembled screw Installation Instructions Visit the ViewZ USA website at http://www.viewzusa.com...
- Page 8 2) After positioning, tight the tilting nuts to hold position Level Adjustment 1) To adjust the level of mount, the monitor can be leveled as ±3 degrees. Loose 2 screws Level the monitor Tight 2 screws Pre-assembled screw Visit the ViewZ USA website at http://www.viewzusa.com Installation Instructions...
- Page 9 VZ-AM03 Notes Installation Instructions Visit the ViewZ USA website at http://www.viewzusa.com...
Need help?
Do you have a question about the VZ-AM03 and is the answer not in the manual?
Questions and answers