Dynojet Power Commander V Installation Instructions Manual page 5

FIG.G
FIG.H
Grey wire
FIG.I
14-001 www.powercommander.com
TPS
9 Locate the stock Throttle Position Sensor. This sensor is located on the left
side of the throttle bodies.
Unplug the stock wiring harness from the sensor which will allow access to the
wires.
10 Using the supplied Posi-tap attach the GREY
wire of the PCV to the OR wire (C) of the TPS
harness (Fig. H).
11 Remove the BLACK plastic engine cover on the left side of the bike by
removing the 3 bolts (Fig. I).
09-11 Ducati M696 PCV - 5