Advertisement
Available languages
Available languages
FEATURES (Fig. A)
1. Trigger switch
2. Lock-On button
3. Motor vents
4. 3 mm Hex key
5. Hex key holder
6. Dust port
7. Tilting sole plate
8. Blade roller
9. Blade screws
10. Chip guard
ASSEMBLY & OPERATION
Warning! Before attempting any of
the following operations, make sure
that the tool is switched o and
unplugged and that the saw blade has
stopped. Used saw blades may be hot.
Warning! Always disconnect your
jigsaw from the power source when
replacing blades, tilting the sole
plate, cleaning or when the tool is not in
use. Disconnecting the jigsaw will prevent
accidental starting that could cause serious
personal injury.
Blade options
Your jigsaw is designed to permit the use of
many di erent saw tooth configurations.
Installing blades (not included)
1. Unplug your jigsaw from the power
source.
Warning! Failure to unplug your jigsaw from
the power source could result in accidental
starting causing serious injury.
2. Insert the slotted screwdriver through
the access hole in the chip shield (10).
Note: Use the slotted screwdriver (not
supplied) to loosen screws.
(Original instructions)
3. Loosen both blade clamp screws (9) and
insert the saw blade (11) as far as possible
into the slot in the blade clamp.
Notes:
a) Ensure the blade is nested in the groove
in the support roller (8).
b) The holes in universal fitting saw blades
are not designed for alignment with the
screw holes in the blade clamp.
4. Tighten both blade clamp screws (9)
securely against the blade.
To remove the jigsaw blade:
1. Unplug your jigsaw.
2. Loosen blade clamp screws (9) using the
slotted screwdriver.
3. Remove the blade.
On/O
trigger switch (Fig. C)
To turn your jigsaw ON, depress the trigger
switch (1). To turn the saw OFF, release the
trigger switch.
Lock-on button (Fig. D)
Your jigsaw is equipped with a lock-on
feature, which is convenient when
continuous cutting for extended periods of
time is required. To lock the switch ON,
depress the trigger switch (1), push in and
hold the lock-on button (2), then release the
trigger. Release the lock-on button and your
jigsaw will continue running. Depress and
release the trigger switch to release lock.
Note: The lock-on button can be accessed
from left side of the handle.
Variable speed control (Fig. E)
(only JS20)
Set the jigsaw speed by rotating the variable
speed control wheel (12) to the appropriate
speed. Rotating the variable speed control
wheel toward the rear of the jigsaw will
result in slower speeds. Position the speed
control dial at "1" for the slowest speed, "3"
for medium speed and at "6" for the highest
speed.
ENGLISH
7
Advertisement
