Table of Contents
Advertisement
Installation References
2
Installing Branching Units
b
Installing Two Branching Units
Install an upper branching unit. Refer to the operations for installing one branching unit.
Install the upper branching unit first.
Lead the lifting sling through the lifting eyes of the branching unit, tie the branching unit
securely, and tie the handle securely using traction slings. Lift the branching unit to the
pole.
The elevation angle between two branching units must be between 135 degrees to
180 degrees.
α
Adjust the azimuth of the branching unit to facilitate installation of the
U-shaped clamp.
Fit U-shaped clamps into the installation holes on the branching unit.
16
Tighten the screws on the U-shaped clamps using an adjustable wrench.
Untie the lifting slings.
Hide quick links:
Advertisement
Table of Contents
