Danfuss VLT 5000 Series Manual page 20

Mains connection from the bottom with built-in
disconnector and fuses
I Motor connection
The motor must be connected to terminals U/T1/96,
V/T2/97, W/T3/98. Earth to terminal 99.
All types of three-phase asynchronous standard mo-
tors can be used with a VLT frequency converter unit.
The factory setting is for clockwise rotation with the
VLT frequency transformer output connected as fol-
lows.
Terminal U/T1/96 connected to U-phase
Terminal V/T2/97 connected to V-phase
Terminal W/T3/98 connected to W-phase
20
®
VLT 5000/6000 Series
The direction of rotation can be changed by switch-
ing two phases in the motor cable.
See Technical data for correct sizing of cable cross-
sections.
See Electrical installation prodedures for how install
the motor connections to the VLT frequency con-
verter.
Motor connection from the side
Motor connection from the bottom
MG.56.A1.02 - VLT is a registered Danfoss trade mark