Danfuss VLT 5000 Series Manual page 19

I Mains connection
Mains must be connected to terminals R/L1/91, S/
L2/92, T/L3/93.
NB!:
Check the name plate to ensure that the
mains voltage of the VLT frequency converter
matches the power supply of your plant.
Ensure that the power supply can supply the neces-
sary current to the VLT frequency converter, see
Technical data.
If the unit is without built-in mains disconnector and
fuses, ensure that the appropriate disconnector or
fuses have the correct current rating.
See Technical data for correct sizing of cable cross-
sections.
See Electrical installation prodedures for how install
the mains connections to the VLT frequency con-
verter.
Mains connection from the side without built-in
disconnector and fuses
MG.56.A1.02 - VLT is a registered Danfoss trade mark
®
VLT 5000/6000 Series
Mains connection from the bottom without built-
in disconnector and fuses
Mains connection from the side with built-in dis-
connector and fuses
19