Configuring Anycast Rp - H3C S9500 Series Operation Manual

Routing switches

Hide thumbs Also See for S9500 Series:

Table of Contents

Operation Manual – MSDP

H3C S9500 Series Routing Switches

[SwitchD] msdp

[SwitchD-msdp] peer 10.25.1.1 connect-interface Vlan-interface30

[SwitchD-msdp] static-rpf-peer 10.25.1.1 rp-policy list-c

1.4.2 Configuring Anycast RP

I. Network requirements

To configure Anycast RP in the PIM-SM domain, establish MSDP peer relationship

between Switch A and Switch B; use the address of Loopback 0 on Switch A and

Switch B to send out SA messages; set Loopback 10 on Switch A and Switch B as

BSR/RP and configure the Anycast RP address. In this way, when a unicast group

member joins, the switch directly connected to the host can originate a join message to

the nearest RP in the topology.

Note:

This example focuses on the configuration of Switch A and Switch B. Configuration

performed on Switch E, Switch D and Switch C is omitted as it mainly concerns

enabling multicast and enabling PIM-SM on the interfaces.

II. Network diagram

Figure 1-4 Network diagram for Anycast RP configuration

III. Configuration procedure

Configure Switch B

# Configure VLAN.

<SwitchB> system-view

System View: return to User View with Ctrl+Z.

[SwitchB] vlan 10

1-14

Chapter 1 MSDP Configuration

Table of Contents