H3C S9500 Series Operation Manual page 14

Operation Manual – MSDP
H3C S9500 Series Routing Switches
After the configuration is complete, Switch D will only receive SA messages permitted
by the corresponding filtering policy from its static RPF peers.
II. Network diagram
Vlan-interface 30
Switch C
Figure 1-3 Configure static RPF peers
III. Configuration procedure
Configure Switch D as follows:
# Configure Switch A to be a static RPF peer of Switch D.
<SwitchD> system-view
System View: return to User View with Ctrl+Z.
[SwitchD] ip ip-prefix list-a permit 10.10.0.0 16
[SwitchD] msdp
[SwitchD-msdp] peer 10.10.1.1 connect-interface Vlan-interface 10
[SwitchD-msdp] static-rpf-peer 10.10.1.1 rp-policy list-a
[SwitchD-msdp] quit
# Configure Switch B to be a static RPF peer of Switch D.
[SwitchD] ip ip-prefix list-b permit 10.21.0.0 16
[SwitchD] msdp
[SwitchD-msdp] peer 10.21.1.1 connect-interface Vlan-interface 20
[SwitchD-msdp] static-rpf-peer 10.21.1.1 rp-policy list-b
[SwitchD-msdp] quit
# Configure Switch C to be a static RPF peer of Switch D.
[SwitchD] ip ip-prefix list-c permit 10.25.0.0 16
PIM-SM 1
10.1.1.1
Switch A
Static RPF peer
SA
Vlan-interface 10
PIM-SM 4
Static RPF peer
Switch D
SA
Static RPF peer
PIM-SM 3
Vlan-interface 20
SA
Static RPF peer
PIM-SM 2
Switch B
1-13
Chapter 1 MSDP Configuration