Key Functions And Display - Polaris SLT780 1996 Owner's Safety And Maintenance Manual

SPECIAL PROCEDURES
Key Functions and Display
SPEED: Primary display function, controls left LCD at all times. Displays speed
with .I MPH resolution from 5-75 MPH. Input is received from patented jet intake
fin.
TACH: Default secondary display function, controls Multi-LCD at power on or
when selected by MODE key. RPM annunciator is on when in TACH mode. Dis-
plays RPM with 10 RPM resolution.
FUEL: Primary display function controls left hand bar graph at all times. Displays
in 118 tank increments. Toggles low "FUEL" display and warning LED when fuel
reaches 118 level. "FUEL" will flash in display regardless of Multi-LCD display
mode.
OIL: Primary display function controls right hand bar graph at all times. Displays in
114 tank increments. Toggles low "OIL" display and warning LED when oil reaches 114
level. "OIL" will flash in display regardless of Multi-LCD display mode.
DIST Secondary display function controls Multi-LCD when selected by mode key.
DlST annunciator is on when in DlST mode. Distance is displayed in .I mile incre-
ments from 0 to 999.9. Distance can be reset by pressing the SET key for 4 se-
conds while in DlST mode.
VOLT: Secondary display function controls Multi-LCD when selected by mode
key. VOLT annunciator is on when in VOLT mode. Voltage is displayed in .1 volt
increments from 5 to 18 volts.
ENGLISHIMETRIC: While in the VOLT mode, pressing and holding SET will
toggle the instrument between MPH and KPH. The distance function is automati-
cally toggled at the same time.
LOW POWER: If battery voltage drops below 10.9 volts, the Multi-LCD display will
flash "LOPR". If this occurs, the speed and distance functions will cease until pow-
er is restored.
HIGH TEMP.: When a hot enginesignal is received, the Multi-LCD display will flash
"HOT" and the warning LED will light.
WARNING RESET: When warning conditions occur, pressing the SET key will
deactivate the warning depending on the condition:
HOB:
Only LED is disabled for
5
minutes: FUEL: Both LED and LCD are disabled for
5
minutes; OIL: Both LED
and LCD are disabled for
15
minutes.
ONlAUTO ON: When system is off, a single press of MODE key will turn the MFD
on. When the engine is started, the MFD will automatically power on.
AUTO OFF: After 5 minutes of no activity, the system automatically shuts itself off.
The internal clock continues to keep time. Memory functions (distance, hours,
MPHIKILO) are retained, and the clock, fuel level, and oil level will be displayed.