Specifications - Sony CMT-CP100 Operating Instructions Manual

There is a severe hum or noise ("TUNED" or
"STEREO" flashes).
l
Adjust the antenna.
* The signal strength is too weak. Connect an
external antenna.
l
Make sure that the antenna is connected
properly.
l
Do not bend or roll up the antenna.
l
The two wires comprising the PM antenna have
been pulled further apart since the system was
first purchased. Repair or replace with a new
one.
l
The AM antenna wire is detached from the stand.
l
Keep the antennas as far away from the speaker
cords as possible.
Amplifier section
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6-ohm loads, both channels driven, from
70 - 20,000 Hz; rated 18 watts per channel
minimum RMS power, with
no
more than 0.9%
total harmonic distortion from 250 milliwatts to
rated output.
North American model:
A stereo FM program cannot
be received in
stereo.
- Press STEREO/MONO on the remote until
"STEREO" appears in the display.
Resetting the system
With the system turned on, press TAPE
n
,
CD
n
and TUNER BAND at the same time.
The system is reset to the factory settings. All
previous settings are cleared and must be set
again.
Messages
One of the following messages may appear or
flash in the display during operations.
NO DISC
l
There is no CD on the disc tray.
PGM FULL
* You try to program 25 tracks or more
Continuous RMS power output (reference):
35 + 35 w
(6 ohms at 1 kHz, 10%
THD)
Total harmonic distortion less than 0.07% (6 ohms at
1 kHz, 18 W)
3
European model:
DIN power output (rated): 30 + 30 W t
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
i
35 + 35 w
3
(6 ohms at 1 kHz, 10%
THD)
3
Music power output (reference):
M
85 + 85 W
C
:
Other models:
The following measured at 230 V AC, 60 Hz
DIN power output (rated): 27 + 27 W
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
32+32W
(6 ohms at 1 kHz, 10%
THD)
The following measured at 220 V AC, 60 Hz
DIN power output (rated): 23 + 23 W
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
26 + 26 W
Inputs
(6 ohms at 1 kHz, 10%
THD)
AUDIO IN MD (VIDEO) (phone jacks):
Sensitivity 500/250 mV,
impedance 47 kilohms
outputs
OPTICAL DIGITAL OUT (CD):
Optical
PHONES:
Accepts headphones with
an impedance of 8 ohms
or more
SPEAKER: 6 ohms
continued*'