Program Play; Using The Cd Display - Sony CMT-CP100 Operating Instructions Manual

- Program Play
You can make a program of up to 24 tracks on
a CD in any order that you want.
1
Turn FUNCTION until "CD" appears in
the display.
2 Press PLAY MODE repeatedly until
"PGM" appears in the display.
3 Press CD HIHI repeatedly until the
desired track number appears in the
display.
Selected track
Total playing time
number
4 Press PLAY MODE.
The selected track is programmed.
The selection number appears in the
display.
5 To program additional tracks, repeat
steps 3 and 4.
6
Press CD HI (or CD ) on the remote).
To
Do this
Cancel Program Play
Press PLAY MODE
repeatedly until "PGM"
disappears from the display.
Add a track to the end Do steps 3 and 4 with
of the program
Program Play stopped.
Erase the entire
Press CD n with Program
program Play stopped.
Tips
* The program you made remains after Program Play
finishes. To play the program again, switch the
function to CD, and then press CD HI (or CD W
on the remote).
- "--.--" appears in the display when the total program
time exceeds 100 minutes.
Press DISPLAY on the remote repeatedly.
The display changes as follows:
During normal playback
Current track number and elapsed playing time
of the track --, Current track number and
8
remaining playing time of the track +
Remaining playing time of the entire CD -+
Clock display + Current track number and
elapsed playing time of the track -+ . . . . .
While the CD is stopped
Total playing time + Clock display +
Current source display + Total playing time
4
Note
If the CD contains 25 tracks or more, the remaining
playing time of the current track will appears as
.'---.--" for each track starting with the 25th.
9