Husqvarna 525HE3 Operator's Manual page 3

Symbols on the product
Stop.
This product can be dangerous and cause
serious injury or death to the operator or
others. Be careful and use the product
correctly.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Always wear approved protective gloves.
Use stable boots with non-slip soles.
Stop the product fully before you touch the
cutting tool.
Keep all parts of your body away from the
hot surfaces.
Fuel.
Choke.
yyyywwxxxxx
Note: Other symbols/decals on the product refer to
special certification requirements for some markets.
Euro V Emissions
WARNING: Tampering with the engine voids
the EU type-approval of this product.
1173 - 001 -
The rating plate shows the serial number. yyyy is the production year and ww is the
production week.
Air purge bulb.
Idle adjustment screw.
High speed needle.
Low speed needle.
There is no electrical insulation in this
product. If the product touches or comes
near high voltage power lines, it can cause
serious injury or death to the operator.
Electricity can move between different
objects by a curve. The higher the voltage,
the longer the electricity can move.
Electricity can also move through branches
and other objects, especially if the object is
wet. Always keep a distance at a minimum
of 10 m/33 ft between the product and high
voltage power lines. Make sure that the
power is off before you start the work near
the power lines. Keep a distance at a
minimum of 15 m/50 ft to other persons or
animals during the operation.
This product applies with the applicable EC
Directives.
Noise emissions to the environment
according to European Directive 2000/14/EC
and New South Wales legislation "Protection
of the Environment Operations (Noise
Control) Regulation 2017". Noise emission
data can be found on the machine label and
in the Technical data chapter.
Product liability
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
3