Know Your Unit; Assembly Instructions - Troy-Bilt TBAH Operator's Manual

Drive Shaft
Assembly
ASSEMBLING THE COUPLER
WARNING:
Read and understand operator's manual
for unit to be used with this add-on prior to operation.
WARNING:
To avoid serious personal injury and
damage to the unit, shut unit off before removing or
installing add-ons.
Installing the add-on:
NOTE: To make installing or removing the add-on easier, place the
unit on the ground or on a work bench.
1. Remove the hanger from the top of the shaft housing.
2. Turn knob counterclockwise to loosen (Fig. 1).
90˚ Edge
Trimming Hole
Tighten
3. While firmly holding the add-on, push it straight into the
coupler (Fig. 2).
NOTE: Aligning the release button with the guide recess will help
installation (Fig. 3).
CAUTION:
Lock the release button in the primary
hole (Fig. 2) and securely tighten the knob before
operating this unit.
4
Indexing Ring
Adjustment Bolt
Angle
Adjustment
Handle

ASSEMBLY INSTRUCTIONS

Loosen
Knob
Fig. 1

KNOW YOUR UNIT

WARNING:
this product. It is not designed to be used with an
extension and using one may cause serious injury.
Coupler
Upper Shaft
Housing
Coupler
4. Turn the knob clockwise to tighten (Fig. 1).
The hedge trimmer add-on should be installed with the release
button in the primary hole.
CAUTION:
to be used in the primary hole only. Using the wrong
hole could lead to personal injury or damage to the unit.
Blade
DO NOT USE an extension boom with
Release Button
Primary Hole
Lower Shaft
Knob
Fig. 2
Release Button
Guide Recess
Knob
Fig. 3
The add-ons with the coupler system are
Housing