Checking The Accuracy; Level Accuracy; Vertical Accuracy - Makita SKR200 Manual

EN

Checking the accuracy

Level accuracy

1
x
1
30m (100ft)
90°
3
y
1
30m (100ft)

Vertical accuracy

1
16
1 Place laser on leveled tripod
approximately 30 m from a
wall. Align the X-axis so that it
is square to the wall.
Switch on the laser. Use
automatic mode and allow the
laser to self-level. Mark the
position of the beam with the
receiver (Position 1).
3
Align the Y-axis by rotating
the laser 90° so that this axis
is square to the wall. Allow the
laser to self-level completely,
and then mark the position of
the beam (Position 3).
Place laser in lay down position on a flat, level
surface, approximately 10 m from a wall.
Hang a plumb line on the wall. Switch on the
laser. Use automatic mode and allow the laser
to self-level. Align the vertical beam to the
plumb line. Use scan operation to have best
visibility.
If the vertical beam is not plumb, adjustment is
necessary.
180°
2
x
2
30m (100ft)
180°
4
y
2
30m (100ft)
Makita SKR200
2
Rotate the laser 180°,
allow it to self level
and mark the
opposite side of the
first axis (Position 2).
4
Rotate the laser
180°, allow it to self
level and mark the
position of the beam
(Position 4).
The laser is within its
accuracy
specification if the
four marks are within
±3mm (± 1/8") from
the center.
Should the laser be
outside of the
specified
tolerance, please
contact a local
dealer.