Magnetic Autocontrol MPT-333 Operating Instructions Manual page 51

Correct positioning of the centre pillar
IMPORTANT!
Observe correct positioning. The countersink on the switching
cam (item 1) must point forward into the zone controlled (ZC).
The centre pillar must be mounted such that the bracket row
(item 3), which is opposite to the countersink on the underside
of the centre pillar flange (item 2), is in the locked position.
3
Fig. 21: Correct positioning of the locking unit – illustration shows version "Entrance
side right"; in version "Entrance side left", the centre pillar is turned by 180°.
A Front
1 Countersink on switching cam. The countersink must point forward into the zone not
controlled.
2 Countersink on the flange bottom of the centre pillar. The bracket row (item 3) op-
posite this countersink must be in the locked position.
3 Bracket row of the centre pillar opposite from the countersink on the flange bottom
on the centre pillar
1
2
MPT-333
Assembly
51