GRAUPNER HYDROPOWER Assembly Instructions Manual

Assembly instructions for the GRAUPNER HYDROPOWER model boat, Order No.
2066
The model

ARTR (Almost Ready To Run)

GRP hull, pre-painted, with decals applied

Factory-installed 26 cc petrol engine, designed for 1 : 25 two-stroke petrol mixture

Zero-maintenance electronic ignition system and integral pull-cord starter

Centrifugal clutch between motor and propeller shaft system; propeller does not rotate when engine is
idling

Externally mounted safety switch ("kill switch") for stopping the engine

Completely factory-assembled model boat, with heavy-duty flexi-shaft supported in aluminium shaft
strut, aluminium rudder system with integral water cooling pick-up, 26 cc petrol engine with water-cooled
cylinder head, pre-fitted exhaust manifold and silencer, fueltank installed and connected, splashproof
RC system box

Set contents: GRP hull with hatch cover, petrol engine, silencer, exhaust manifold, flexi-shaft drive
system, propeller, rudder system, fueltank, RC fittings, RC box and small items

For additional information on petrol-engined power boats we recommend that you read the following
book: Verbrenner-Powerboats, Karl-Friedrich Kaupert, vth-Verlag, ISBN 3-88180-748-9 (in German).
Specification
Overall length approx.
Beam approx.
All-up weight approx.
Manufacturer's declaration from Graupner GmbH & Co. KG
Content of the manufacturer's declaration
If material defects or manufacturing faults should arise in a product distributed by us in the Federal Republic
of Germany and purchased by a consumer (§ 13 BGB), we, Graupner GmbH & Co. KG, D-73230
Kirchheim/Teck, Germany, acknowledge the obligation to correct those defects within the limitations
described below.
The consumer is not entitled to exploit this manufacturer's declaration if the failure in the usability of the
product is due to natural wear, use under competition conditions, incompetent or improper use (including
incorrect installation) or external influences.
This manufacturer's declaration does not affect the consumer's legal or contractual rights regarding defects
arising from the purchase contract between the consumer and the vendor (dealer).
Extent of the guarantee
If a claim is made under guarantee, we undertake at our discretion to repair or replace the defective goods.
We will not consider supplementary claims, especially for reimbursement of costs relating to the defect (e.g.
installation / removal costs) and compensation for consequent damages unless they are allowed by statute.
This does not affect claims based on legal regulations, especially according to product liability law.
Guarantee requirements
The purchaser is required to make the guarantee claim in writing, and must enclose original proof of
purchase (e.g. invoice, receipt, delivery note) and this guarantee card. He must send the defective goods to
us at his own cost, using the following address:
Gliders
Brunel Drive, Newark, Nottinghamshire, NG242EG
The purchaser should state the material defect or manufacturing fault, or the symptoms of the fault, in as
accurate a manner as possible, so that we can check if our guarantee obligation is applicable.
The goods are transported from the consumer to us and from us to the consumer at the risk of the consumer.
GRAUPNER GmbH & Co. KG
No liability for printing errors. We reserve the right to introduce modifications.
1221 mm
590 mm
8 kg
D-73230 KIRCHHEIM/TECK
1
GERMANY
04/2011