Jet JTS-315LA-M Operating Instructions Manual page 7

is mounted on the left front side (see Fig. 1 & Fig. 3).
Screw the side struts (O) and legs (J) loosely together.
Mount the diagonal strut (U) as shown in Fig. 3
Tighten all nuts.
Mount the rubber feet (P) on the legs.
Mount the wheel supports (22, Fig. 4) to the rear legs (J) with
screws (33).
Turn the saw upside down and place it on the legs.
Mount angle brackets (a, Fig. 5) to the legs (J) with screws (b).
This allows bolting the machine to the floor.
Fig. 3
Fig.4
Install dust port:
Fasten the dust port (S, Fig. 6) to the bottom of the chip box
(Q) with 4 screw (U).
Install switch:
Insert the switch (C, Fig. 7) into the leg opening and fasten
with 2 screw s (C1).
Install saw blade:
See chapter 7.1
Install raving knife:
See chapter 7.2
Install table insert:
Position the table insert (B, Fig. 8) into the table top, and lock
with 4 screws (B1).
Fig.5
Fig. 6
Fig. 7