Table of Contents
Advertisement
Turn on the spot (Steering lever fully squeezed)
The track on the side to which you are to turn turns in the reverse
direction, which makes the snow thrower turn on the spot (corrects
the direction on the spot).
CENTER OF SNOW THROWER
OPERATOR
CENTER OF
TURN
OPERATOR
Drive motor control protection system
This snow thrower is designed to drive with the motor power. When
an excessive load is applied to the motor, which depends on an
operation condition of the snow thrower, the protection circuit is
armed making the drive control warning indicator (orange) blink and
possibly slowing down or stopping the snow thrower.
If this symptom occurs, release the drive clutch lever and stop the
work. Keep the engine switch in the ON position and wait until the
drive control warning indicator (orange) does not blink. If the drive
control warning indicator (orange) goes off, it indicates that the snow
thrower has been restored to its normal condition and you can
continue clearing snow.
Note that the protection system functions frequently if the motor is
under an excessive load. Adjust the load to a proper level.
The snow thrower might be faulty if the engine does not restart or the
drive control warning indicator (orange) blinks when restarting the
engine. Move the snow thrower to a safe place by removing the wheel
pins from the tracks and check for the trouble by referring to the
symptom-to-troubleshooting table (see pages 108 and 109). Have your
authorized Honda snow thrower dealer check and repair your snow
thrower if necessary.
See page 120 for wheel pin removal.
STEERING LEVER
(Squeeze fully)
Track turns in the
reverse direction.
Track turns in the
normal direction.
71
Advertisement
Table of Contents
