Table of Contents
Advertisement
RESET SWITCH (ETDR type)
AUGER HOUSING CONTROL SWITCH
MAIN SHIFT
LEVER
DRIVE CLUTCH LEVER
66
N (neutral)
3) Operate the auger housing
control switch to adjust the
auger to be parallel to the road
surface (see pages 53 through
55).
[ETDR type]
• You can return the auger to
the initial position by pushing
the reset switch.
• If you return the auger to the
initial position by pushing the
reset switch, the auger can hit
against the road surface or
can be raised from the road,
resulting in some snow left
on the ground, depending on
the road condition and the
position of the snow thrower.
Adjust the auger position as
needed.
4) Check that the main shift lever
is in the N (neutral) position and
squeeze the drive clutch lever.
Advertisement
Table of Contents
