2.
Place chute assembly onto chute base and secure chute
control assembly to chute support bracket with clevis pin
and cotter pin removed earlier. See See Fig. 3-3.
3.
Finish securing chute control assembly to chute support
bracket with wing nut and hex screw removed earlier.
See Fig. 3-4.
8
s
2— a
ectiOn
sseMbly
Figure 3-3
Figure 3-4
& s
-u
et
p
4.
Check that all cables are properly routed through the cable
guide on top of the engine. See Fig. 3-5.
Figure 3-5
Set-Up
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. Store them in your snow
thrower's dash panel until needed. See Fig. 3-6.
Figure 3-6