Sunrise Medical Jay J2 User Instruction Manual & Warranty page 3

EASY MAINTENANCE, CLEANING, & ASSEMBLY*
Monthly cleaning and regular maintenance may help extend the life of your cushion.
During cleaning, component inspection is recommended. Check the cover for
tears and excessive wear and inspect the fluid pad(s) for punctures or any other
abnormalities. Check the foam base to ensure that any accessories are still in the
correct position.While checking the fluid pad(s) if you ever feel the fluid is firmer
in one area, simply knead the fluid back to its original consistency and/or call your
local authorized supplier.
* Please refer to your specific fluid cushion section for any additional maintenance,
cleaning, or assembly instructions.
To clean cover
Remove the cover from the foam base.Turn the cover inside out, zip closed,
and machine wash in warm water and drip or tumble dry on low heat. No
ironing required.
Note: Do not dry clean covers or use industrial washers and dryers to clean
cover. Do not steam autoclave. Do not bleach.
To refit cover after washing, reinstall any accessory items or fluid pads, then fit
cover back over foam base. Ensure the back of the cover matches up to the
back of the foam base.
Note: If utilized in an institutional setting, write the resident's name with a
permanent marker on the content label of the covers.This will help to ensure
the return of the covers after washing.
Use only Jay-designed covers on Jay fluid cushions.
Regular washing of AirExchange™ or Tritex™ covers will help restore
and improve the breathing and comfort qualities.
To clean foam base
Remove the cover, fluid pad(s), and any accessory parts from the foam base.
Wipe with warm water and soap.Wipe off with a clean cloth.
Note: Avoid submersion of the foam base in water.
Reinstall any accessory items and fluid pad(s), then fit cover back over foam
base. Ensure the back of the cover matches up to the back of the foam base.
To clean fluid pad(s)
Remove the cover from the foam base. Remove fluid pad(s) and wipe with
warm water and soap.Wipe off with a clean cloth.
Reinstall fluid pad(s), then fit cover back over foam base. Ensure the back of
the cover matches up to the back of the foam base.
To clean accessory parts
Remove the cover from the foam base and fluid pad(s), if necessary, to clean
accessory parts. Remove accessory parts.Wipe with warm water and soap.
Wipe off with a clean cloth.
Reinstall accessory parts and fluid pad(s), then fit cover back over foam base.
Ensure the back of the cover matches up to the back of the foam base.
3
XT2105 Rev. J