Advertisement
Instruction Manual MX-500N / MV-500NII Series
Features
Overview (Page 5)
Limit knobs
Crosshead
Force gauge mount
Table
Rear view (Page 6)
Inlet
Fuse case
I/O Connector
MX series only
EN-00 Connector
MX/MV-E series only
Operation panel (Page 7)
Emergency button
Power switch
Speed volume
FS volume
FS button
Mode button
Up/Down buttons
LEDs
Upper / Lower travel limits are ... by those knobs. Turning left
to loosen. Tighten after sliding them up or down to any
position.
Goes up or down with force gauge.
Mount the force gauge here. There are certain holes suitable
for Imada brand force gauges.
Put a sample here or fix a fixture with GF-1 grip mount.
Plug power cord (included)
A fuse is in this case
Connect certain force gauge here to use "Force control
mode" through an optional cable CB-501
Connect a speed / Length meter EN-00 here
Force to stop the test stand by pressing this button for
emergency situation. To release the button, turn it left.
For MX series, you must return the test stand power on to
use it again.
Turn on/off the power of the test stand
Adjust travel speed of the crosshead in no-step.
Adjust travel speed when you select "Fix speed (FS)" mode.
Seal this hole if you won't change speed.
Enable/Disable "Fix speed" mode
Select modes
Indicate test stand movement
Display current mode and movement
8
Manual No. MXV50801E
Advertisement
