Advertisement
Instruction Manual MX-500N / MV-500NII Series
Mounting force gauge
Mounting digital/mechanical force gauge
1. Unscrew two flap-nuts, and release the force gauge mount with taking care not to slip
the mount down.
2. Tighten force gauge to mount with remaining M6 flat-head screws in the hole.
3. Insert the tip of M6 flat-head screws into the holes on the crosshead. Tighten it by
flap-nuts.
Especially the force gauge of low capacity breaks down according to over load also by
small force. Please pay your attention that an attachment tip does not hit a table.
Screws (included)
Screws (included)
M6 flat head screws
M6 flat head screws
Flap nuts
Crosshead
Force gauge mount
12
Manual No. MXV50801E
Advertisement
