Advertisement
Instruction Manual MX-500N / MV-500NII Series
Single/Continuous cycle operation and I/O connection with the force gauge are excluded
for MV series.
Operation
Press
or
Press
or
Keep pressing
for 2 seconds.
Keep Pressing
for 2 seconds.
Press
while running
Crosshead stops always whenever it reaches limit knobs.
Be sure to keep watching on force value so that it does not exceed its capacity. In
any mode, any display and even power off, overloading causes failure of your force
gauge.
Do not apply force in irregular direction, or it will be broken down even if the
displayed value is within its capacity.
Do not use the gauge for other usage than tension / compression measuring.
Some protection is needed when you measure container with contents.
Operating MV series
Crosshead runs to the
direction of button figure at
its maximum speed.
Crosshead runs to the
direction of button figure at
the speed indicated by
speed volume.
Crosshead
or
moving
release button.
Crosshead
or
moving
release button.
Crosshead stops.
or
Caution in measuring
Motion
continues
although
you
continues
although
you
21
RUN LED
Dark→
Light
Dark→
Light
Light→
Blink
Light→
Blink
Blink→
Dark
Manual No. MXV50801E
Advertisement
