Advertisement
Instruction Manual MX-500N / MV-500NII Series
Length/Speed Meter (only with MX/MV-500N-E)
About...
MX/MV-500N-E series has a built-in rotary-encoder which makes it possible to measure
travel length and speed by sensing rotation of its feed screw. You can see those
measurements with a display unit EN-00 included with.
Length
Speed
Connection
Rear view of the test stand
Operation
After plugging EN-00, turn on the test stand to display length and speed. Press zero
button when the crosshead is at the original position. Speed is always displayed.
Please refer the instruction manual for EN-00 for details.
Never plug or unplug the display unit while the test stand is powered, or it would
cause the display unit failure.
The display unit may not display anything when you turn the test stand on right after
turning the unit off. Please wait at least 3 seconds for turning it on.
Display unit EN-00
After turn off the power of the test stand,
plug it into "EN-00" connecter on the rear
side of the unit.
Display unit
14
Zero button:
Zero the display
HOLD button:
Holds the display while pressing
Manual No. MXV50801E
Advertisement
