Advertisement
Instruction Manual MX-500N / MV-500NII Series
Screwing attachment(s)
prevent it from overload.
to select "Manual Operation"
1.
Press
（
2.
Press
want to stop.
3.
Loosen upper (lower) limit knob
4.
Move limit knob until it touches the crosshead.
5.
Tighten limit knob.
1. It is "Manual Operation" mode when turn the power on.
2. Whenever pressing
Operation"→"Single cycle"→"Continuous cycle". LED displays current mode.
Procedures
Optional attachment
Sample
Optional attachment
Adjusting upper and lower limit
） to drive crosshead to upper (lower) limit position whether you
Selecting mode (MX)
, current mode switches in the sequence "Manual
15
If needed, use optional
attachment or standard
attachment mounting on the
sensing shaft of the force gauge.
1. When
you
attachment on the table side,
please attach GF-1 on a table.
2. To mount an attachment for
tensile force, use M6 screw
standing on the GF-1 and fix it
at certain angle by a nut.
3. Never use any tool to tighten
an attachment to the sensing
shaft of the force gauge to
Manual No. MXV50801E
attach
an
Advertisement
