Battery Protection System; Turbo Button - Makita DFJ206 Instruction Manual

Indicator lamps
Lighted Off
(For 14.4 V and 18 V batteries only)
(For 14.4 V and 18 V batteries only)
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.

Battery protection system

The device is equipped with a battery protection sys-
tem. This system automatically cuts off power to the
motor to extend battery life.
If the remaining battery capacity is too low, the device
will not operate. When you turn the device on, the motor
will run again, but stops soon. In this situation, remove
and recharge the battery cartridge.

Turbo button

By pressing turbo button on the battery holder, the
jacket works in turbo mode for quick cooling. Turbo
mode lasts for a minute and then air speed returns to
normal.
1
► 1 . Turbo button
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Air flow
To maintain a stable air flow, close the button at the
neck of the jacket. Fasten the button on the ribbon for
better air flow in the back.
► 1 . Ribbon
Air flow inside the jacket is shown below.
For a jacket with a hood, wear the hood over a helmet.
The air from the fan goes through the helmet and cools
your head.
9 ENGLISH
1