Application Restrictions; Pre-Check; Protection Degree - SBM AMC 12 Installers And Users Instructions

Modulating and condensing gas warm air heater
Table of Contents

Advertisement

1. APPLICATION RESTRICTIONS

1.1 Pre-check

Before unpacking and installation, please check (i.e. on the data badge) if the heater is in accordance with
the order and if it is suitable for the local present provisions (gas type, gas pressure, electrical supply etc.)
The Installation must comply with all applicable local and national standards.
If this heater is drawing its combustion air from within the room in where it is located, the necessary
combustion ventilation requirements must be followed for gas safety regulations.
Make sure that the warm air can be blown out freely. There should absolutely be (no possibility of)
materials within 5m from the front of the heater.
The heaters have been tested in detail on safety and correct operating settings before leaving the factory. It
has been adjusted for the type of gas that is stated on the data badge.
If there is any doubt, please contact SBM.

1.2 Protection degree

The appliances have been designed for a use in a dry and not very dusty environment (protection degree
IP20).
The heater should not be installed in areas containing any corrosive or explosive steam, in high moisture or
dust concentrations, at negative pressures or temperatures higher than 30°C; please consult SBM. The
guarantee is then invalidated.
The installation and maintenance of this air heater should be performed by an authorized
competent installer and in accordance with this manual.
The appliance shall be CE marked.
Respect the safety clearances with the inflammable materials.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance.
In case where the air intake is done inside the room (type B connection), provide a
sufficient ventilation by referring to the rules in force.
4

Advertisement

Table of Contents
loading

Table of Contents