Advertisement
APPENDIX B - SECTION 1
TABLE 1
DPU ERROR CODES - CONT'D
Other codes (See footnote at bottom of this page.)
R1 = 13XX
SOFTWARE "CMD" MODULE ERRORS
These errors may be caused by inValid entries to the "CBLD"
command of the DPU.
Follow recovery procedure in Section 1.8.
R1 = 1301
Command Directive invalid
R1 = 1302
Command argument required decimal digit
R1 = 1303
Command argument requires smaller digit
R1 = 1306
Command includes an argument error
R1 = 130F
Command error due to missing or faulty argument
R1 = 1324
Command specifies invalid device type
R1 = 132A
Command specifies duplicate channel
R1 = 1339
Command device error,
cannot read label
R1 = 13XX
R2 = CDXX
SMTCS COMMAND PROCESSOR INIT ERRORS
R2 = CDOC
Fatal I/O error
R2 = CDOD
Non—fatal I/O error
R2 = CDXX
Other codes (see footnote below.)
This is the final stage of bootload.
Failures detected
during this init phase will halt the DPU with error codes
in R1 and R2.
To retry, clear R1 and press RUN.
(Ref.
CMD Error Retry Section 1.8.)
Footnote:
All codes listed as XX are concerned with the DPU
operating system software.'
The DPU 0/8 is not
accessible by, or manipulated by the DPU user.
However,
for your information,
all
codes are defined
in LEVEL 6 Manual.
B-5
Advertisement
