Table of Contents
Advertisement
3.2 Switching on the control box
1.
Turn on the control box (slide the ON/OFF button on the
control box)
2.
During the connection phase, LEDs 1, 3 and 5 Flash.
3.
The case lights up, the display shows: connected, then
goes to the default display of the Yomper (control unit
autonomy level and Yomper autonomy).
4.
The LED Strip flashes green at the first speed (indoor
mode).
5.
The power button LED on the Yomper will no longer
blink.
You are ready to use the Yomper.
NB: by default, your enclosure is factory connected with your Yomper. It is possible to pair it with another
case, see setting up the Yomper.
25 / 46
Advertisement
Table of Contents
