Advertisement
Setup without the Data terminal:
There is a LED indicator and a pushbutton to allow setup the unit without the data
terminal. In this case the options are considerably reduced from the full options
available using the data terminal.
Connect the RC channels you want to use (Gear In obligatory, Brake In and Steering In
optional). Set the Steering In (Rudder channel) in the position you want that the
steering servo be placed during retraction and gear up position.
Leave the main battery disconnected to prevent accidental movement of motors.
Switch off the power. Press the button with the aid of a plastic rod (a pen, etc, but
nothing metallic that could damage the electronic board). While the button pressed,
switch on the power on the receiver.
When receiver powered, release the switch.
The blue LED will light intermittently, one short flash with a long pause between
flashes.
Set your transmitter at the position you want the gear to be retracted.
Once the TX set, press the switch again. Hold it pressed until it lit continuously, this will
indicate that the command received from the TX as been stored as "Gear Up"
command.
Release the button, the led will blink 2 short times followed by a long pause. Repeat
the procedure described above for to memorize the remaining radio commands:
1 blink -> Gear Up command
2 blinks -> Gear Down (extended) command
3 blinks -> Brake OFF. The unit will detect if signal present on Brake In, if not will
assume single channel mode.
4 blinks -> Brake maximum.
5 Blinks- > Steering servo retracted position.
NOTE: Executing this procedure will set all remaining adjustments to the factory
defaults, all delays, door servo positions, steering servo adjustments will be reset to
default. This procedure allow to use the controller in simple models without the need of
a data terminal.
Advertisement
