Advertisement
asseMblY
7
Locate Drawer Front G and lay flat so the side with 6 holes faces up. Insert
Cam Bolts O into the upper hole along each short side and tighten with a
screwdriver. Insert Dowels Q into the 2 holes just below the Cam Bolts. Be
sure the Dowels are firmly inserted by gently tapping with a rubber mallet.
Attach the Drawer Handle L using two Screws R as shown.
Insert Cam Lock Nuts N in the hole above the drawer runner on each
Drawer Side. Turn so the small arrow points toward the adjoining hole in the
edge of the Drawer Side.
Insert the Cam Bolts and Dowels on the Drawer Front into the holes drilled
in the edge of each Drawer Side. Turn the Cam Lock Nuts clockwise with a
screwdriver to tighten.
Hardware Used:
8
Install the drawer by aligning the drawer runners with the
drawer tracks as shown and pushing all the way in to
attach the runners to the tracks.
Your Tribeca Collection Bedside Table is ready for use!
9
If needed, the drawer can be removed (e.g. for cleaning). Open the
drawer all the way, then lift and press the levers on both drawer
tracks at the same time to pull the drawer all the way out.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
N Cam Lock Nut x2
O Cam Bolt x2
Q Dowel x2
R Screw (M4x20mm) x2
O
N
Q
Ensure the drawer runners are aligned.
Lift/press the levers to remove the drawer.
O
Q
R
L
6
Advertisement
