Advertisement
asseMblY
4
Locate Table Bottom C. Position so holes in Table Bottom
align with holes in edges of Table Sides and corners are flush
and previously-installed Dowels are inserted into the middle
hole on each side of the inside of the Table Bottom.
Insert 4 Screws P through the 4 holes drilled in the Table
Bottom and into the holes drilled in the Table Sides. Tighten
with a screwdriver. Do not overtighten.
Hardware Used:
5
Install the first Leg Frame A by finding the holes drilled
near one end and aligning them with the holes drilled in
the Table Top B and Table Bottom C. Insert 4 Screws M
through the Leg Frame and into the Table Top and Table
Bottom. Tighten using the Hex Key T.
Repeat to install the second Leg Frame.
Carefully turn the unit upright.
Hardware Used:
6
Assemble the drawer: locate Drawer Sides H/I and Drawer Back K.
With the drawer runner on Drawer Side I facing out and the
grooves on both pieces aligned on the inside, connect Drawer Side
to Drawer Back using 2 Screws S as shown. Tighten using a
screwdriver.
Repeat to connect Drawer Side H to Drawer Back.
Slide the Drawer Bottom J into the groove formed by the Drawer
Sides H/I and Drawer Back K as shown. Make sure it is securely
and squarely seated in the groove.
Hardware Used:
Contact us for assistance: (866) 985-7877 | www.wtliving.com
P Screw (M4x40mm) x4
M Screw (M7x48mm) x8
S Screw (M4x30mm) x4
P
P
A
A
M
M
M
M
S
H
K
S
I
P
P
C
M
M
M
M
B
J
5
Advertisement
