Advertisement
asseMblY
PREPARATION
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts are missing,
please contact Customer Service before proceeding.
Place all parts on a soft, level surface for assembly. You will need a Rubber Mallet and Phillips
Estimated Assembly Time: 0 Minutes | DO NOT over-tighten hardware!
1
Locate the Table Top B and place it so the side with drilled
holes face up. Insert and tighten 4 Cam Bolts O into the 4 holes
closest to the corners of the Table Top as shown. Insert 2
Dowels Q in the remaining 2 holes midway down the shorter
sides, as shown. Be sure the Dowels are firmly inserted by
gently tapping with a rubber mallet.
Locate the Drawer Front G and place it so the side with drilled
holes face up. Insert and tighten 2 Cam Bolts in the holes near
the middle of each short edge as shown. Set aside.
Hardware Used:
2
Locate the Table Sides D/E and insert 4 Cam Lock Nuts N
into the holes below the pre-installed drawer track on each
piece. Turn Cam Lock Nuts so the arrow points toward the
adjoining hole drilled in the bottom edge.
Align the groove in Table Side (Right) D perpendicularly to
the groove in the Table Top and slide the Table Side onto the
hardware installed earlier, as shown. Secure the Table Side to
the Table Top by turning the Cam Lock Nuts clockwise until
tight.
Repeat to install the Table Side (Left) E.
Insert a Dowel Q into the hole drilled in the center of the top
edge of each Table Side. Be sure the Dowels are firmly
inserted by gently tapping with a rubber mallet.
Hardware Used:
3
Slide the Table Back F into the groove formed by the Table
Sides D/E and Table Top B as shown. Make sure it is
securely and squarely seated in the bottom of the groove.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
O Cam Bolt x 6
Q Dowel x 2
N Cam Lock Nut x 4
Q Dowel x 2
screwdriver for assembly.
O
O
Q
O
O
B
O
Q
N
D
N
M
Q
D
B
F
B
D
O
G
N
E
N
Q
E
E
4
Advertisement
