Table of Contents
Advertisement
Getting Started
6. Confirm with "Apply". The "Connection Properties" dialog box appears
(Figure 3-9).
Figure 3-9
7. Check the settings (interface and type) as in Figure 3-9.
8. Accept your entries by clicking "OK".
The first connection has thus been created. The second connection is created in
an analogous manner. Begin at step 1 with the CPU 416-1.
STEP 7 enters the connection in the connection table of the local node and
assigns to this connection the local ID and, if applicable, the partner ID that you
require when programming the communication function blocks (value for the "ID"
block parameter).
These settings conclude the configuration of the "Router" project.
9. Load the data in the relevant station.
3-12
Connection Properties
Windows Automation Center WinAC Slot 412/WinAC Slot 416 Version 3.1
A5E00065531-03
Advertisement
Table of Contents
