Asko OCSM8487 Series Instructions For Use Manual page 14

INITIAL USE
EN 14
Setting the time
TIME l HOUR
11
12
13
1. Turn the selection knob and change the hours.
2. Confirm this setting by touching the right navigation key or by
pressing the selection knob.
3. Turn the selection knob and change the minutes.
4. Confirm this setting by touching the confirm key.
Setting the water hardness
WATER HARDNESS
1 red
The water hardness must be set prior to initial use.
If the water is softer or harder than the default setting, you can alter the
set hardness level.
Checking the water hardness
You can measure water hardness using the 'paper test strip' supplied
with your appliance. For information about water hardness in your
region please contact your local water board.
Using the 'paper test strip'
Dip the test strip in water for 1 second. Wait 1 minute and read the
number of bars on the paper strip. Check the table for the correct water
hardness setting.
Setting the water hardness
1. Compare the test strip with the image on the display.
2. Turn the selection knob until the bars on the screen correspond
with those on the test strip.
3. Touch the confirm key to save the set water hardness.
The equipment has now been programmed so that the descaling
notification will appear in accordance with the actual water hardness.
:
Soft water
00