Encoder Services; Encoder Configuration; Source Configuration (Sdi) - Sencore DMG-4100 User Manual

11.3 Encoder Services

Once audio and video profiles have defined, services can be configured. Service configuration links
physical inputs (SDI ports) to profiles. Services are defined using the Encoder Service application.
If there is a mismatch between input resolution (e.g. HD) and configured output resolution (e.g. SD) the
encoder will try to convert resolution. When resolution conversion is not possible, alarms will be raised.
When opening up the application, you will be presented with a list of active encoded services. If none
are present, they can be created on the left hand panel.
To remove active services from the configuration, you can click on the red '-' on the required channel
and click 'Save'.

11.3.1 Encoder Configuration

The configuration of the encoder has two modes
• Initial configuration
• Configuration modification
For initial configuration, you must first define the physical input source and the configuration is
performed on the left hand panel.
For already configured serivces, these can be modified by selecting the service and selecting the
'Output' tab on the right hand panel. Once changed are made here, you will need to click the 'Save'
button for the settings to be applied.
Both mechanisms have the same parameters and these are described below.
11.3.1.1

Source Configuration (SDI)

2020-02-13
User Guide
Page 45 (105)