Controls Before Start Up; Body; Filters - VENCO VHR Series Installation, Operation, & Maintenance Instruction

Figure 7.2.4. Repair Warning
Label
Figure 7.2.6. Ground Label
Figure 7.2.9. Access door label
Figure 7.2.12. Fresh Air label

8. CONTROLS BEFORE START UP

Please make sure that all electricity cables are made according to (EN 60204 -1) standards and security
and protection units belong to all elements. Please make sure that all parts of the unit are clean. There
can be duct insulation residuals, bands etc.

8.1. Body

Please check the inside of product, are there any particles which can damage the unit. Please check both
inside and outside of product are there any damages were happened because of mechanical reasons. If yes,
please note the main reason and apply the precautions not to go wider. If necessary please contact with
VENCO.

8.2. Filters

2016.09
Figure 7.2.5. Wiring Diagram
Label
Figure 7.2.7. Fan(Spinning)
Label
Figure 7.2.10. Filter Access door
label
Figure 7.2.13. Exhaust air label
Figure 7.2.8. Electrical warning
Label
Figure 7.2.11. Drain label
Figure 7.2.14. Air flow direction
label
13 / 28