Table of Contents
Advertisement
Step 6:
Enter "CALIBRATION VOLTAGE".
Adjust the voltage on the display to match the voltage measured
in Step 1. Use SW9 to increase and SW10 to decrease value.
Press SW8 to save and exit voltage calibration.
9. F5S-IQ TEMPERATURE CALIBRATION (optional equipment)
The F5S-IQ system provides an optional connection for up to 3 temperature sensor modules.
To calibrate the temperature follow these steps:
Step 1:
Using a thermometer, record the temperature were the temperature sensor is installed.
Step 2:
Repeat Step 2 to Step 6 from previous section: "8. F5S-IQ VOLTAGE CALIBRATION" .
Step 3:
Enter "CALIBRATION TEMPSENSOR 1".
Adjust the temperature on the display to match the temperature measured in Step 1.
Use SW9 to increase and SW10 to decrease value.
Step 4:
Press SW8 to save.
If a second temperature sensor is present, repeat Step 3 to calibrate TempSensor 2.
If not, the system will exit temperature calibration process.
Step 5:
Press SW8 to save.
If the third temperature sensor is present, repeat Step 3 to calibrate TempSensor 3.
If not, the system will exit temperature calibration process.
Step 6:
Press SW8 to save and exit temperature calibration.
10. F5M-IQ TOUCHPAD BACKLIGHT QUICK SETTING
The F5M-IQ system provides a 6 level quick adjustment for the touchpad backlight.
To make a quick adjustment of the touchpad backlight follow these steps:
Step 1:
Press and hold down SW1.
Step 2:
After 3 seconds the backlight quick adjustment is enabled. Keep holding down SW1.
Step 3:
Every couple of seconds the touchpad will beep and change the backlight to the next intensity
level. Once the highest level is reached it will start a new cycle by selecting the lowest backlight
level.
Step 4:
Once the desired backlight level is selected, release SW1. The new backlight level is saved and
the touchpad will resume the normal operation.
9
July 31, 2019
- Quick Links:
- 7-F5S-Iq Touchpad Programming
Hide quick links:
Advertisement
Table of Contents
