Steps
1. Locate the heatsink slot on your computer.
2. Align and place the heatsink fan on to the heatsink assembly.
3. Install the single (M2x5) screw that secures the heatsink fan to the heatsink assembly.
4. Align and place the heatsink assembly into the slot of your computer.
5. Install the two (M2x5) and six (M2x3) to secure the heatsink assembly to the computer.
NOTE:
Install the screws as per the callout on the heatsink.
6. Connect the heatsink fan cable on to the connector on the system board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
solid state
5. Remove the HDD.
6. Remove the
WLAN
card.
7. Remove the
WWAN
card.
8. Remove the
inner
frame.
9. Remove the
heat
sink.
10. Remove the
memory
module.
About this task
The figure indicates the location of the system board and provides a visual representation of the removal procedure.
After working inside your
computer.
Before working inside your
drive.
computer.
Disassembly and reassembly
83